Da-Lite TENSIONED EXECUTIVE ELECTROL Manuel d'installation Page 3

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 2
The picture surface drop, and the opening and closing of the fabric door, are controlled automatically by limit switches
which have been preset at Da-Lite. When the picture surface is moving upward, it is controlled by a limit switch that shuts
off when the door closes. The height for tensioned screens are adjusted at Da-Lite, changing the height of screen will
change the tension on fabric and cause the screen to hang improperly. Do not adjust.
ACCESS DOOR INSTALLATION
SCREEN ADJUSTMENT
2
1. Press switch “down” so that fabric door opens (Fig. 2).
2. Remove screws (2) located on each bumper bracket.
NOTE: The access door is slotted on one edge, permitting the slotted section to fit over the access panel clips on inside of case.
3. Place access panel so slot can be pushed over clips. Holes in access panel brackets should align with bumper
bracket holes.
4. Replace screws.
5. Make sure there is approximately
3
16" clearance around access door. Keep paint, plaster, tile or mastic out of hinge.
Fit access panel so it can be removed for maintenance.
CROSS SECTION
BUMPER
BRACKET
ACCESS PANEL SCREW
(PAINTED)
PICTURE
SURFACE
ACCESS PANEL
FABRIC DOOR
ACCESS
PANEL CLIP
FALSE TOP
FIGURE 2
INSTALLATION
4. If you are going to cover screen door with paneling or other materials, allow access (suitable holes or a plug) to
screws for servicing.
5. Picture surface should hang freely. (Fig. 2) Remove any tape left hanging on back of fabric. Bottom edge should be
positioned between bottom edge of case and center of roller.
6. Install electrical hook up that applies to your unit. Unit should be wired by a qualified electrician.
7. Test installation by carefully running picture surface “up” and “down” several times. Be prepared to stop screen.
Fabric door must open freely to 90˚.
8. Make sure picture surface, when rolled down, has a full wrap around roller. No part of roller should be exposed.
Fabric door and picture surface will drop simultaneously when switch is pressed “down”. Door will close simultane-
ously with picture surface as picture surface rolls into case.
Vue de la page 2
1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire