Da-Lite EXECUTIVE ELECTROL Manuel d'utilisateur

INSTRUCTION BOOK FOR Executive® Electrol®

10

11

LIMITED ONE YEAR WARRANTY ON DALITE PRESENTATION PRODUCTSMilestone AV Technologies LLC warrants certain Da-Lite branded products to the original purc

2Pre-Installation1. Carefully unpack screen and remove outer wrapping from case.2. Remove fabric and cardboard strips from access door.3. Remove a

3Installation1. Install screen by raising unit into position between joists at one end only. Install one lag screw in each mounting bracket. Secure

41. Press switch “down” so that fabric door opens (Fig. 3).2. Remove screws (2) located on each bumper bracket. NOTE: The access door is slotted on

5Restoring Roller WrapExecutive Electrol® Installation CAUTION! Do not attempt to restore a lost wrap by adjusting limit switches! ATTENTION! N&apo

6Executive Electrol® InstallationBlackRed (Up)BlueBlackWhiteWhiteRedUp Limit Switch(Operated By Door)CapacitorBlack(Down)Down Limit SwitchSolenoid Swi

7Symptom Cause Solution Screen will not operate or will not go “down”.Motor does not hum.Blown fuse. Replace fuse.Tripped circuit breaker. Reset circ

8Symptom Cause SolutionScreen will not move “up.” Motor does not hum.Motor hums.No power between red and white leads in junction box. Check LVC. See a

9Symptom Cause SolutionScreen jammed. Will not operate, motor hums, door open, closing mechanism detached from door.Closing mechanism detached from do