Da-lite Multi Mask Imager Manuel d'utilisateur

INSTRUCTION BOOK FOR Multi-Mask Imager

2Unpacking and Unrolling the ScreenThe viewing side of the screen surface is rolled to the inside. The screen surface is rolled lengthwise.1. Remove

3Figure 4Attaching the Screen Surface to Frame1. Place the frame over the screen surface.2. While lifting the frame with one hand, snap the screen s

4Installing the High Voltage Switch Control (Standard)Three standard 3-position wall switches are supplied. The high-voltage control is connected to t

5Figure 7Side CoverOpeningSide1. Attach the wall brackets to the wall using appropriate fasteners at previously marked locations.When you lower or re

6123456Modifying the Extension of the Mask1. You can increase the extension of a mask up to 3" past the factory preset stop, or you can decrease

7TroubleshootingRefer to the following guidelines if you encounter a diiculty in the operation of your Da-Lite Multi-Mask Imager screen. Problems r

LIMITED ONE YEAR WARRANTY ON DALITE PRESENTATION PRODUCTSMilestone AV Technologies LLC warrants certain Da-Lite branded products to the original purc